Hewlett Packard 438A
Power Meter, Refurbished

• 100 kHz to 50 GHz
• -70 dBm to +44 dBm
• Programmable digital averaging filter
• Dual channel design
• Available Options, Below

Recommended for use with the
8480 Series Power Sensors

HP / Agilent 438A Power Meter Shown

Product Information
Datasheet	1.9 MB
PDF Help

The HP 438A Power Meter is a dual channel power meter designed specifically for ATE systems.  The compact front panel is designed to save space in rack mounted systems, while the dual channel design allows simple measurements of the ratio and difference of power levels from two separate sensors.  Compatible with the HP 8480 series of thermocouple and diode sensors, the power and frequency range of the meter extends from -70 dBm to 44 dBm and from 100 kHz to 50 GHz.

Important measurement contributions are a programmable digital filter for optimizing resolution and measurement speed, independent offset (in dB) values for each channel, 0.001 dB resolution available, and a power difference mode for displaying absorbed power in transmission lines.  Up to 19 different operating states of the meter can be stored into non-volatile memory for later recall.

The programmable digital averaging filter gives the user control over the inherent tradeoff between speed and accuracy.  The AUTO filter mode is usually adequate for fully settled readings with 0.01 dB resolution.  Less digital averaging leads to faster but noisier readings if speed is the critical issue.

The Hewlett-Packard Interface Bus (HP-IB) capability is standard on the HP 438A with programming codes printed on the front panel for easy reference.  For U.S. Air Force MATE (Modular Automatic Test Equipment) system applications, Option 700 provides the HP 438A with the internal capability to be controlled by the MATE language CILL (Control Interface Intermediate Language).  All measurement modes are programmable including zeroing, calibration, and Cal Factor.  Complete interrupt capability with flexible SRQ operation optimizes the efficiency of program execution in automatic systems.