Hewlett Packard 4261A
Digital LCR Meter Specifications

Accuracy applies over a temperature range of 23°C ± 5°C (at 0° to 55°C, error doubles).
Parameters Measured	L-D, C-D R
Display	3-1/2 digits max. display 1900
Basic Accuracy	0.2%
Test Frequency	120 (100) Hz, 1 kHz ± 3%
Test Signal Level (Typical)	1 V, 50 mV (Cp mode only)
DC Bias	Int. 1.5 V, 2.2 V, 6 V ± 5%, selectable Ext. 0 to +30 V
Equivalent Circuit Modes	auto, parallel, series
Ranging Modes	LCR: auto, manual DQ: D only-fixed
Trigger	internal, external, manual
Measuring Terminal	5-terminal configuration
Measuring Time (typical)	for a 1000 count measurement on a low loss component on a fixed range: 1 kHz, 10 kHz: C/L 220-260 ms, R 120-160 ms 120 (100) Hz: C/L 900 ms, R 700 ms
Ranging Time	1 kHz, 10 kHz: 180 ms/range step 120 (100) Hz: 670 ms/range step
Reading Rate	INT (internal trigger) approximately 30 ms between end of measurement cycle is initiated by a remote trigger input.
Accessories Available	16061A: test fixture, direct couple, 5-terminal 16062A: test leads with alligator clips, 4-terminal (for low impedance measurements) 16063A: test leads with alligator clips, 3-terminal (for high impedance measurements)

$20.00 Minimum on Total Order