<< UniSource Oscilloscopes

UniSource EDC-1630
Advanced Digital LCR Meter

• 0.02% ACCURACY, 5-MEASURING MODE
• Displays measured deviation value and deviation rate (%) with respect to the designated standard values.
• Displays automatic BIN numbers by optional setting according to the measured deviation rate.
• If the D/Qppm key on menu-2 is used, resolution is obtained for even the ppm of D or Q.
• If the # Average key on menu-3 is used, the number of measurements can be set up to 2~255 times to display the average values.
• The system features handler interface function capable of controlling the BIN numbers and the measurement start signal of the measured data by means of remote control system.
• The system carries a function which removes the stray capacity of the interface terminals or the line resistance offset prior to starting measurement.
• Measuring Frequency 12Hz ~ 100kHz
• 4-Divided Accuracy and BIN Signal Output

UniSource EDC-1630 Shown
 

Product Information
Datasheet	301 KB
PDF Help

Measuring Function and menu selection concept

Function Selection: 6 Function keys can be used to select measuring functions
 

Resistance value measurement:		Resistance error (%) measurement:		BIN numbers of the measured value:
Displays general R (Resistance value) and the resistor’s Q (quality factor) values.		Displays error rate (%) of the measured value with respect to the optionally set NV (nominal value) reference value. Displays also error value with +/- mark. (Applicable also when L and C are measured)		To distinguish accuracy, numbers are assigned for each error grade optionally set based on nominal value. This means that Bin 0 is treated as the minimum allowable error limit; Bin 1 through Bin 13 as those grades that can pass; while Bin 14 is treated as the maximum allowable error limit in which case a message “Fail” is displayed on the bottom of LCD.
Inductance measurement:		Capacitance measurement I:		Capacitance measurement II:
Displays general L (Inductance Value) and L’s Q (quality factor) value.		Displays general C (Capacitance value) and R value contained in C.		Displays general C (Capacitance value) and C’s D (Dissipation factor) value.