QuadTech 1920
LCR Meter with CE Mark

• 20 Measurement Parameters
• 20 Hz to 1MHz Frequency Range
• 0.1% Basic Measurement Accuracy
• Measurement Speeds Up to 40/sec
• DC Resistance Measurements
• Monitoring of DUT Voltage and Current
• 5 Digit Measurement Resolution
• Programmable DC Bias Voltage, 0-2V
• Constant Voltage (Voltage Leveling)
• IEEE-488, RS-232 & Handler Interfaces, all Standard
• Open/Short Zeroing & Cable Compensation
• Load Correction
• 14 Pass/Fail Bins
• Keypad Lockout

• Fast Production testing of LCR Components and Materials
• AC Impedance & DC Resistance Measurements
• Component Characterization over a Wide Frequency Range
• Component Screening, Evaluation and Design

20 Measurement Parameters Measure and display any two of 15 impedance parameters simultaneously, with a basic accuracy of 0.1%. Additionally the 1920 can measure the DC resistance, or display the current through or voltage across a test device ensuring the operator of the real test conditions.

Wide Frequency Over 27,000 user programmable test frequencies to fully characterize devices over the range of 20 Hz to 1 MHz.

Automatic Test Sequencing For increased productivity and throughput the 1920 can perform up to six different tests in sequence with a single push of the start button. Each test can have different measurement parameters, test conditions and limits.

DC Bias Voltage The instruments internal DC bias voltage source, programmable from 0 to 2 V in 1 mV steps, allows capacitors to be tested under real DC bias conditions.

Setup Storage/Recall The test operator has the ability to store and recall, from internal memory, up to 30 single test setups and 10 sequential setups (six tests in sequence). The front panel can be locked out, with password protection, to ensure that procedures are run the same way every time.

Load Correction Substantially improves instrument accuracy by allowing the operator to specify the value of a known standard, measure it, and apply a correction to ongoing measurements.

Programmable Source Impedance The operator is able to set instrument source impedance at 5, 25, 50 or 100 ohms, an important feature when comparing measurements to those made on other testers. Measurement results can vary substantially based solely on the source impedance of the tester being used.

QuadTech Catalog   |   QuadTech Price List