|
Features |
|
Function |
Descriptions |
|
Multiformat support |
With the formats
available on the LT 450, you can test most video displays,
including television sets, PC monitors, and projectors.
The LT 450 supports 19 component output formats, 8 composite
output formats, and 5 PC monitor formats. |
|
HDMI output |
The LT 450 is equipped with an
HDMI connector, which is a digital interface
used in household televisions and set-top boxes.
It can be used to check HDCP-compliant copyright
protection functions and to make simple checks
on the CEC andDDC functions (PASS/FAIL results
can be displayed on screen).
In all systems, simple checks can be made
simultaneously on up to seven outputs (when
option units are installed).
|
|
G, B, R and Y, PB, PR
signal outputs |
Analog and digital component
outputs can be switched between G, B, R and Y, PB,
PR signal formats. |
|
S connector |
Equipped with an S connector for
Y/C separation signal output. An ID signal is superimposed on
the C signal. |
|
D connector |
Equipped with a JEITA CP-4120 D5
output. Supports ID signals (lines 1, 2, and 3). |
|
RGB Connector |
Equipped with a mini D-sub 15-pin
connector, which is an analog interface for PC monitors. |
|
DVI-I Connector |
Equipped with a DVI-I connector,
which is a digital interface for PC monitors. It can be used to
check HDCP-compliant copyright protection functions and to make
simple checks on the DDC function. |
|
Sync signal output |
Equipped with sync signal
connectors that transmit CS (tri-level or binary), HD, and VD
signals. |
|
Analog audio output |
The frequency (400 Hz or 1 kHz)
can be set and the output can be turned off separately for left
and right channels. |
|
Simple motion picture |
You can make any test pattern
into a simple motion picture pattern by scrolling it vertically,
horizontally, or diagonally. |
|
Variable output level feature |
The video signal level and the
analog sync signal level can be adjusted separately in the range
of 0 to 100 %. |
|
Closed caption and teletext |
Supports closed captions.
Teletext (VBI), CGMS, and WSS will be supported in the future.
|
|
Remote control via RS232C |
The LT 450 can be remotely
controlled from a PC |
|
Preset/recall features |
Up to 100 panel settings can be
stored and recalled. |
|
Output Unit Options (Plug-In Unit for LT
450) |
Output units can be added freely
according to your objectives. |
LT 45SER01
DVI-I Unit |
 |
An output unit with a DVI-I connector.
Can be used to check HDCP-compliant copyright protection
functions and to make simple checks on the DDC function. |
LT 45SER02
HDMI Unit |
 |
An output unit with two HDMI connectors.
Can be used to check HDCP-compliant copyright protection
functions and to make simple checks on the CEC and DDC
functions. |
|
LT 45SER03 SCART Unit |
 |
A PAL- and SECAM-compatible SCART connector unit.
Can used to make simple checks on European AV equipment. |
){kind=small}
118 KB 
PDF Help
