Innoventions Catalog  |  Price List

 

Innoventions RAMCHECK 100 Adapter

Our latest addition to the RAMCHECK line provides needed support for testing of SDRAM and standard EDO/FPM DRAM 100-pin SO DIMM modules at an affordable price.

RAMCHECK automatically detects the presence of the RC 100 Adapter (p/n INN-8668-5). The tester also automatically determines if the tested module is SDRAM or standard DRAM without the need for special setup.

In fact, you can test standard DRAM devices following an SDRAM, or vice versa, without the need of manual settings. Standard DRAM testing is similar to the regular EDO/FPM test procedure.

The RC DIMMCHECK 100 Adapter bursts complex pattern tests, into and from the tested module, at a true 133MHz (or faster) synchronous rate. The automatic test provides the tested module's size, voltage, frequency, and type. RAMCHECK's internal 184MHz test engine verifies that the tested module can accept the various mode commands, including CAS latency of 1, 2, and 3, sequential, or interleave type bursts at different lengths, and the single write mode. It further verifies interleaved bank operation.

Note: This adapter can be used only on RAMCHECK. It is not supported by our other generation of test equipment.

Required RAMCHECK Firmware Version: 2.07

RAMCHECK Adapters