<< Hioki CatalogHioki
3665-20
LAN Cable Hi-TESTER
|
- Can be used to test the wire connection status after installing
LAN cables
- Used to locate the sources of cable errors if operative network
errors are caused by LAN cables. Furthermore, it can be used to check
the cable types (straight or crossover) or the integrity of cables
before the new cables are used.
- Compact and Easy to operate
- Shielded Cables and Crossover Cables Can Also Be Tested
- Detect Split Pairs
- Locate the Source of Errors
- NVP Setting Function
- Confirm the Cable Connection Destination
- Features a beeper and backlight
|
 
Hioki 3665-20 Shown
|
|
|
HIOKI has developed the LAN CABLE HiTESTER 3665-20 that
enables communications technicians to test LAN cables (twisted pair cables).
As networks spread, twisted pair cables are being installed in virtually all
locations such as buildings, factories, apartments and condominiums, and
homes. Accordingly, electrical technicians who previously did not handle
communication cables are increasingly required to install twisted pair
cables. Furthermore, since network communication speeds are increasing, more
accurate installation is required. To make this possible, a LAN cable tester
is used.
The LAN CABLE HiTESTER 3665-20 was developed based on the technology of its
predecessor LAN CABLE HiTESTER 3660 in order to offer a tester that can
efficiently and accurately test the wire connection, cable length, and
connection destination of twisted pair cables. |
|
|
|
Specifications |
|
Measurable cable |
Twisted-pair cable
100ohm characteristic impedance, shielded and unshielded,
CAT 3, 4, 5, 5e and 6 |
|
Compatible connectors |
RJ-45 plugs |
|
Wiremap Check |
Wiring condition and shielding can be
confirmed using the
HIOKI TERMINATOR 9690.
Detectable errors: open, short, reversed, transposed, split pairs
and other miswiring |
| Cable
Length Check |
Measurable lengths: 2 to 300 m, 6.6 to 984 ft
Measurement accuracy: ± 4% rdg. ± 1 m, ± 4% rdg. ± 3.3 ft
Display resolution: 0.1 m, 0.3ft |
| Direction Check |
Up to
21 cables can be identified using the supplied TERMINATOR 9690 and
optional Models 9690-01 to 9690-04 |
|
Display |
128 x
64 dot matrix LCD (with backlight) |
| Functions |
Auto
Backlight: pressing a button turns the backlight on (it turns off
automatically after about 20 seconds)
Beeper: sounds when pressing buttons and when measurement results
are displayed
Energy-Saving Mode: enter into energy-saving mode after measurement
(and resume when the TEST button is pressed)
Auto Power Save: the 3665-20 turns off automatically about 10
minutes after the last button press
Battery Check: Battery indicator blinks when voltage falls below 2.4
V
Unit Switch: Select between meters or feet |
| Power Supply |
Two
AA-size (LR6) alkaline batteries 1.4VA Approx. 50 hours |
|
Dimensions, Mass |
Approx. 85 W x 130 H x 33 D mm, approx. 160 g |
|
|
|
| Ordering Information |
| Model |
Description |
Buy Online |
Price |
| 366520 |
Hioki 3665-20 LAN Cable Hi-TESTER - Special Price! |
 |
$272.95
(Reg. $299.95) |
| Included Accessories |
| |
- 1 - Terminator
- 1 - Carrying Case
|
Included |
|
)
PDF
Help