Hameg Catalog | Hameg Price List

 

<< Hameg Oscilloscopes

Hameg HM303-6
Standard Oscilloscope

• Vertical: 2 Channels, DC - 35MHz, 1mV/div. - 20V/div.

• Time Base: 0.2s to 10ns/div.; Variable Hold Off; Alternate Triggering

• Triggering: DC-100MHz; Auto Peak to Peak; Active TV Sync. Separator

• Additional Features: Component Tester, 1kHz/1MHz Calibrator

The Hameg HM303 oscilloscope succeeds the HM203 (over 180,000 sold worldwide). The bandwidth has been extended from 20 to 35MHz, the sweep speed increased to 10ns/div. and improvements added to the already legendary HAMEG auto triggering system.

Hameg HM303-6 Shown

Product Information
Datasheet	103 KB
Manual	925 KB
PDF Help

The HM303 is the ideal instrument for waveform display in the DC to 100MHz frequency range.

A key feature of this oscilloscope is the vertical amplifier's pulse fidelity, with overshoot less than 1%. The HM303 offers a special fast rise time 1 kHz/1 MHz Calibrator, permitting high quality probe compensation across the entire frequency range to ensure probe tip thru to display integrity. The HM303 is capable of triggering on input waveforms over 100MHz at very low signal amplitudes. Alternate triggering mode enables the display of two asynchronous signals simultaneously. An active Video Sync. Separator permits detailed examination of complex TV signal inputs. A well proven, built-in component tester is now equipped with a stabilized measuring voltage. The use of a switching type of power supply minimizes both weight and power consumption and universally accepts a wide range of input power line voltages, without the requirement to change jumpers or switch positions.

The HM303's CRT is fully mu-metal shielded against outside magnetic fields.

Hameg is setting new price/performance breakthroughs with the introduction of this fine oscilloscope. This performance packed scope will tempt all users to run it through its paces.