AEMC 3731
Clamp-On Ground Resistance Tester

Simple and fast clamp-on operation - no leads, no auxiliary rods or spacing requirements. No need to disconnect neutral service
Direct reading of ground resistance from 0.1 Ohm to 1200 Ohms
Direct reading of continuity and ground loop resistance
Direct reading of ground leakage current from 1 mA to 30 Amps rms
Large 1.38" Jaw opening
Auto-off
Adjustable Alarm Set-point
Store 99 field measurements in memory for later retrieval and analysis

AEMC 3731 Shown

Product Information
Datasheet	480 KB
PDF Help

Applications

Measures ground rod and small grid resistance.
Use in multi-grounded systems without disconnecting the ground under test.
Measure resistance and continuity of grounding loops around pads and buildings.
Measure leakage current flowing to ground or circulating in ground loops.
Conduct quick field checks.
Conduct field surveys and retrieve and analyze readings are a later time.

Check Resistance on Single and Multiple Rods or Grids
Clamp-on Ground Resistance Testers are used in multi-grounded systems without disconnecting the ground under test. The Model 3731 simply clamps around the ground conductor or rod and measures the resistance to ground. By performing measurements on intact ground systems, the user also verifies the quality of the grounding connections and bonds. Resistance and continuity of grounding loops around pads and buildings may also be measured.

Ordering Information
Model	Description	Buy Online	Price
3731	AEMC 3731 Ground Resistance Tester (Clamp-On) (#2117.61) - Special Price!		$1,570.50 (Reg. $1,745.00)
Included Accessories
	1 - 9V Battery 1 - Hard Carrying Case 1 - 25Ω Calibration Check Loop 1 - Instruction Manual	Included

AEMC 3731 Clamp-On Ground Resistance Tester

AEMC 3731
Clamp-On Ground Resistance Tester